Repair & Reship Service
Please ship ONLY the bare unit or the defective part. Do NOT include any accessories or loose parts — keep your original build plate, UV lid, and ALL removable components at home.
Minimizing the shipment size helps reduce weight and significantly lowers the risk of damage during transit — including resin spills, carbon powder leaks, scratches, and dents.
This is what happens when accessories are left rattling inside the box:
A unit that arrives with this level of cured-resin contamination — caked over the screen, Z-axis, and rails — will be declined and returned unserviced. Please clean the unit thoroughly before shipping.
A clogged hotend is not covered by the manufacturer's warranty, on any brand. Clearing a blob like these is an out-of-pocket repair, quoted per service action plus parts.
A note goes INSIDE the box, on top of the machine. If you have a repair ticket with us, you can print the slip from your portal — or hand-write these three lines on any sheet of paper, big and clear, like this:
That note is how receiving matches the box to your ticket the moment it opens.
Again, we will return a BARE unit only. For resin printers that means the base and U frame; for FDM units, the base, U frame, and print head — no PEI sheet. Please keep ALL your original accessories.
We are NOT able to perform cosmetic repairs (e.g. cured resin, dirty build plates) — we are only instructed to repair and replace the major components and hardware.
For service orders outside warranty coverage: if the repair is not pre-approved under warranty, labor fees will be quoted for EACH service action (e.g. clogged printhead, resin leaked into LCD, firmware restoration), plus the cost of parts.
For unapproved service orders, a prepaid return shipping label will be REQUIRED to return the unit back to the sender.
Please refer to your carrier tracking number — tracking serves as the legal proof of a parcel's delivery status.